7-4 MaintenanceCleaning the Interior

CAUTION

The qualified service representative can only install or remove the components described in this subsection. To avoid personal injury or electrical shock, contact your service representative when your need to install/remove the internal components.

One of the most important items in a good maintenance program is regular and thorough cleaning of the interior of the server, especially around the mother board.

Dust buildup inside the server can lead to several problems. As dust acts as a thermal insulator, a buildup can prevent proper system cooling. Excessive heat will shorten the life of server components. Also, dust may contain conductive or corrosive materials that can cause short circuits or corrosion of electrical contacts.

How often you should clean the interior of the server depends on the environment in which it is located. For most office environments, you probably should clean the server every 12 months. For more severe environments, clean the interior every 6 months.

Cleaning the interior of the server entails powering off the server and removing the left side cover. You will need a small vacuum cleaner (with plastic tipped nozzle and electrostatic protection), computer grade canned air, and a small brush for cleaning the interior.

Follow the procedure below to clean the interior of the server.

WARNING

Unplug all power cords.

Unplug all power cords before performing any maintenance. Voltage is present inside the server and display unit even after the power is turned off. All voltage is removed only when the power cord is unplugged.

IMPORTANT: Do not use the brush made of chemical fabric, or the cleaning material that will generate an electrostatics.

1.Turn off the server and unplug all power cables.2.Remove the left side cover. (See Chapter 9.)3.Remove the dust accumulate on the air inlet of the front and the rear fan.4.Use a small brush to loosen any dust and debris on the mother board.

5.Use computer grade canned air to blow dust off components on the mother board.

6.Use a small vacuum cleaner with plastic tip to vacuum out dust and debris from the interior of the server.

7.Reinstall the left side cover. (See Chapter 9.)8.Reconnect all power cables and turn on the server.