Upgrading Your Server 9-49

Installation

Install a file device in the following procedure. Explanations are for factory-installed file bay. Explanation specific for hard disk drive installing kit is also described.

SCSI Device1.Provide the proper setting for the device.

See the table below for the settings of the devices which can be installed in the device bay.

Device

Setting

SCSI device

Termination resistance: OFF*

*If the terminator is not connected to the optional internal SCSI cable, set the termination resistance to ON.

IMPORTANT: SCSI ID for the device you are installing must be unique.

2.See the section "Preparing for Installation and Removal" described earlier to prepare.

3.Remove the left side cover and front mask as described earlier in this chapter.

NOTE: If you are going to install the hard disk drive device bay conversion kit, remove the dummy cover from the additional slot 2.

4.Remove the two screws securing the dummy cover of the additional slot 1.
IMPORTANT: Keep the removed dummy cover for future use.