NEC 5800/230Eh manual 185

Troubleshooting 8-9

Error	Error message	Recommended Action
code
02D1	System Memory exceeds the CPU's caching	Contact your service representative.
	limit.
02F4	EISA CMOS not write able.
02F5	DMA Test Failed.
02F6	Software NMI Failed.
02F7	Fail-safe Timer NMI Failed.
0B22	CPUs are installed out of order.	Request the maintenance to replace the CPU.
0B28	Unsupported CPU detected on CPU Slot 1.	Make sure that the server supports the CPU. If
0B29	Unsupported CPU detected on CPU Slot 2.	you are not sure, contact your service
		representative to request the maintenance.
0B30	Fan 1 Alarm occurred.	Contact your service representative to replace
0B31	Fan 2 Alarm occurred.	the fan.
0B32	Fan 3 Alarm occurred.
0B5F	Forced to use Processor with error	Because an error is detected in every CPU,
		the system is forcibly started. Contact your
		service representative.
0B60	DIMM group #1 has been disabled	Contact your service representative.
0B61	DIMM group #2 has been disabled
0B62	DIMM group #3 has been disabled
0B63	DIMM group #4 has been disabled
0B64	DIMM group #5 has been disabled
0B65	DIMM group #6 has been disabled
0B70	The error occurred during temperature	Contact your service representative.
	sensor reading.
0B71	System Temperature out of the range.	Contact your service representative to replace
		the fan.
0B74	The error occurred during voltage sensor	Contact your service representative.
	reading.
0B75	System voltage out of the range.
0B80	BMC Memory Test Failed.	Turn off the power once and then on again to
0B81	BMC Firmware Code Area CRC check failed.	start the server. If the error cannot be
		corrected, contact your service representative.
0B82	BMC core Hardware failure.
0B83	BMC 1BF or 0BF check failed.
0B8A	BMC SEL area full.	Start SETUP and select [Server] - [Event Log
		Configuration] - [Clear All Error Logs] and
		press Enter to clear event logs.
0B8B	BMC progress check timeout.	Turn off the power once and then on again to
0B8C	BMC command access failed.	start the server. If the error cannot be
0B8D	Could not redirect the console - BMC Busy -	corrected, contact your service representative.
0B8E	Could not redirect the console - BMC Error -
0B8F	Could not redirect the console - BMC
	Parameter Error -
0B90	BMC Platform Information Area corrupted.
0B91	BMC update firmware corrupted.