NEC 5800/230Eh IMPORTANT:, Saving the Configuration Data

4-8 Configuring Your Server

Saving the Configuration Data

IMPORTANT: If the SATA hard disk drives are used in disk array configured with the on-board HostRAID, be sure to select [Advanced] - [Peripheral Configuration] - [SATA Controller Mode Option] - [Enhanced]. Then, select [Advanced] - [Peripheral Configuration] - [SATA RAID Enable] - [Enabled]. Leaving this parameter as the factory-set value (Disabled) may destroy the data in hard disk drive.

To save the current configuration data

Select [Exit] - [Exit Saving Changes] or [Save Changes].

To discard changes to the current configuration data

Select [Exit] - [Exit Discarding Changes] or [Discard Changes].

To load the user-defined default

Select [Exit] - [Load Setup Defaults].

To load the custom defaults

Select [Exit] - [Load Custom Defaults].

To save the custom defaults

Select [Exit] - [Save Custom Defaults].