NEC 5800/230Eh manual 186

8-10	Troubleshooting
Error		Error message	Recommended Action
code
0B92		Internal Use Area of BMC FRU corrupted.	This is not a fatal error. Turn off the power
			once and then on again to restart the server. If
			the error cannot be corrected, contact your
			service representative.
0B93		BMC SDR Repository empty.	Turn off the power once and then on again to
			restart the server. If the error cannot be
			corrected, contact your service representative.
0B94		IPMB signal lines do not respond.	This is not a fatal error. Turn off the power
			once and then on again to restart the server. If
			the error cannot be corrected, contact your
			service representative.
0B95		BMC FRU device failure.	This is not a fatal error. Turn off the power
			once and then on again to restart the server. If
			the error cannot be corrected, contact your
			service representative.
0B96		BMC SDR Repository failure.	Turn off the power once and then on again to
0B97		BMC SEL device failure.	start the server. If the error cannot be
			corrected, contact your service representative.
0B98		BMC RAM test error.
0B99		BMC Fatal hardware error.
0B9A		Management controller not responding.	Update the RMC firmware. If the error cannot
			be corrected, contact your service
			representative.
0B9B		Private I2C bus not responding.	Turn off the power once and then on again to
0B9C		BMC internal exception.	start the server. If the error cannot be
0B9D		BMC A/D timeout error.	corrected, contact your service representative.
0B9E		SDR repository corrupt.
0B9F		SEL corrupt.
0BB0		SMBIOS – SROM data read error.	Contact your service representative.
0BB1		SMBIOS – SROM data checksum bad.
8100		Memory Error detected in DIMM group #1.	Contact your service representative to replace
8101		Memory Error detected in DIMM group #2.	the DIMM in the relevant group.
8102		Memory Error detected in DIMM group #3.
8103		Memory Error detected in DIMM group #4.
8104		Memory Error detected in DIMM group #5.
8105		Memory Error detected in DIMM group #6.
8160		Mismatch Processor Speed detected on	Contact your service representative.
		Processor 1.
8161		Mismatch Processor Speed detected on
		Processor 2.
None		Expansion ROM not initialized – PCI Mass	Disable initialization of the optional device
		Storage Controller in slot xx (xx: slot number)	expansion ROM by using the BIOS SETUP
			utility (see Chapter 4).
		H/W Configuration of BMC is corrupted.	Use the NEC EXPRESSBUILDER to
		!! Update BMC F/W Configuration by	configure the optional remote management
		configuration tool !!	card (see Chapter 6).
		!! Refer to BMC configuration manual !!