NEC 5800/230Eh manual 87

		Configuring Your Server 4-23
Option	Parameter	Description	Your Setting
Boot Monitoring	[Disabled]	Specify whether to enable or
	Every 5 minutes	disable the boot monitoring
	between 5 minutes	function on booting, or select the
	and 60 minutes	time limit for timeout.
		To use this function, install NEC
		ESMPRO Agent. Set this item to
		"Disabled" if the system is booted
		from OS without installation of
		NEC ESMPRO Agent.
Boot Monitoring	[Retry 3 Times]	Specify the processing at the
Policy	Retry Service Boot	occurrence of timeout during boot
	Always Reset	monitoring.
		If [Retry 3 times] is selected, the
		system is reset after the
		occurrence of timeout and OS boot
		is retried up to three times.
		If [Retry Service Boot] is selected,
		the system is reset after the
		occurrence of timeout and OS boot
		is retried up to three times. Then
		the boot is tried from the service
		partition for three times. The failure
		in the third boot causes the system
		to stop booting.
		If [Always Reset] is selected, the
		system is reset after the
		occurrence of timeout and OS boot
		is retried repeatedly.
		* If no service partition exists in
		the system, OS boot is retried
		repeatedly from the system
		partition.
Thermal Sensor	Disabled	Specify whether to enable or
	[Enabled]	disable the thermal sensor
		monitoring function. If a thermal
		error is detected with this item
		being set to "Enabled", the system
		stops at the end of POST.
BMC IRQ	Disabled	Set the IRQ for BMC.
	[IRQ 11]
Post Error Pause	Disabled	Indicates whether POST is aborted
	[Enabled]	once at the end of POST if an error
		occurs during the execution of
		POST.
AC-LINK	Stay Off	Specify the state of power when
	[Last State]	the AC power to the server is
	Power On	turned off once and then on. (See
		the table below.)