6-10 Installing and Using Utilities

Starting

The following two methods are available to start the server.

„Running NEC EXPRESSBUILDER from the management PC via LAN

„Running NEC EXPRESSBUILDER from the management PC via direct connection (COM B)

For the procedure for starting NEC EXPRESSBUILDER for DOS-based with Remote Console, see "NEC DianaScope".

IMPORTANT:

„Do not change the boot device order in BOOT menu in BIOS SETUP. NEC EXPRESSBUILDER cannot be used if the DVD- ROM drive is not the first device to launch the system.

„To use the remote console feature, a floppy disk containing a configuration information file must be inserted in the floppy disk drive. You can create a configuration information file by using System Management feature in the Tools menu or by NEC DianaScope Configuration menu. The configuration information file must be named as "CSL_LESS.CFG" and stored in the root directory of the floppy disk.

NOTE: The following items of BIOS setup information will be set as shown below.

„

LAN Controller:

[Enabled]

„

Serial Port A:

[Enabled]

 

Base I/O Address:

[3F8]

 

Interrupt:

[IRQ 4]

„

Serial Port B:

[Enabled]

 

Base I/O Address:

[2F8]

 

Interrupt:

[IRQ 3]

„BIOS Redirection Port: [Serial B]

„

Baud Rate:

[19.2K]

„

Flow Control:

[CTS/RTS]

„

Console Type:

[PC ANSI]