NEC 5800/230Eh „After storage of device, „After carriage of device, 4-10Configuring Your Server

4-10 Configuring Your Server

The items which can be set on the Main menu screen and their functions are described below.

Option	Parameter	Description	Your Setting
System Time	HH:MM:SS	Set the system time.
System Date	MM/DD/YYYY	Set the system date.
Hard Disk Pre-Delay	[Disabled]	Allows slower spin-up drives to
	3 seconds	come ready.
	6 seconds
	9 seconds
	12 seconds
	15 seconds
	21 seconds
	30 seconds
Primary IDE Master	–	Shows the information on the
Primary IDE Slave		device connected to each
Secondary IDE Master		channel on the submenu. If only
Secondary IDE Slave		one hard disk drive is connected
		to serial ATA channel, the
		information is displayed on area
		for Primary IDE.
		The settings of some items may
		be changed. However, leave the
		items as they are at the
		shipment.
Processor Settings	–	Shows the processor settings
		submenu. See the next page.
Language	[English (US)]	Select which language BIOS
	Français	displays.
	Deutsch
	Español
	Italiano
		[	]: Factory-set

IMPORTANT: Check and adjust the system clock before the operation if any of the following conditions is applicable.

„After carriage of device„After storage of device

„After the device is entered into the pause state under the environmental condition enduring device operation (temperature: 10°C - 35°C, humidity: 20% - 80%)

Check the system clock at the rough rate of once per month. When the system clock is installed in a system requiring high time precision, it is recommended to use a time server (NTP server).

If the system clock is remarkably delayed or advanced as the passage of time in spite of adjustment, contact your service representative for maintenance.