Upgrading Your Server 9-47

Removal

To remove the CPU, prepare for removal referring to steps 1 and 3 in the installation procedure and do the reverse procedure of steps 11 to 4. To remove the heat sink, first remove the screw, and slightly move the heat sink at a level, then remove the heat sink.

IMPORTANT:

„Do not remove any CPU unless it is failed.

„After the operation, heat may make the cool seat at the bottom of the heat sink adhere to the CPU. To remove the heat sink from the CPU, first turn the heat sink to the left and right lightly to make sure that the heat sink can be apart from the CPU. Removing the heat sink with it adhering to the CPU may cause the CPU and/or socket to be damaged.

Do the following procedure if a CPU is removed (or replaced).

1.Start SETUP to select menus [Main] – [Processor Settings] – [Processor Retest] in the order to clear the error information on the removed CPU (see Chapter 4).

When a CPU is replaced, select menus [Main] – [Processor Settings] to confirm that the ID and L2 Cache Size of the additional CPU are defined normally (see Chapter 4).

2.Set [Reset Configuration Data] on the Advanced menu to [Yes].

This is required to update the hardware configuration information. See Chapter 4 for details.