4-30 Configuring Your Server

IMPORTANT: This option sets [SATA RAID Enabled] in the [Advanced] - [Peripheral Configuration] menu to [Disabled]. If the SATA hard disk drives are installed in your server and the onboard SATA RAID feature is used, change the parameter of the [SATA RAID Enabled] from [Disabled] to [Enabled] before exiting BIOS Setup. Leaving this parameter as the factory-set value (Disabled) may destroy the data in hard disk drive.

NOTE: To display the [SATA RAID Enabled] menu, select [Advanced] - [Peripheral Configuration] - [SATA Controller Mode Option] - [Enhanced].

Load Custom Defaults

Select this item and press Enter to load the custom defaults stored. This menu does not appear if the Custom Defaults are not saved.

Save Custom Defaults

Select this item and press Enter to save the parameters currently being edited as custom defaults. When the parameters are saved, the Load Custom Defaults menu appears.

Discard Changes

Select this item to return the values modified currently to the previous values before saving the values to CMOS.

Save Changes

Select this item to save the newly selected information to CMOS (non-volatile memory) without the termination of SETUP.