Setting Up Your Server 3-5

When you have selected a server site, hold the server by its bottom with at least three persons and carry it to the site, then place it slowly and gently.

IMPORTANT: Do not hold the server by its front mask to lift the server. The front mask may be disengaged and damage the server.

Do not install the server in the following locations as it may cause malfunctions of the server.

„Places with drastic changes in temperature (e.g., near a heater, air conditioner, or refrigerator)

„Places with strong vibration

„Places with corrosive gas in presence, near chemicals, or with possibilities of chemicals sprayed over

„On a non-antistatic carpet

„Places with possibilities of falling objects

„Places where a power outlet that shares the ground line with another (especially the one to which a device with large power consumption is connected) must be used for the server

„Places near a device generating intense magnetic field (such as a TV, radio, broadcast/communication antenna, power transmission wire, and electromagnetic crane) is placed

„Places near equipment that generates power noise (e.g., contact spark at power-on/power off of commercial power supply through a relay). If you must install the server close to such equipment, request your service representative for separate power cabling or noise filter installation.