NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

17-2 Port Mirroring

v1.0, May 2008
Example #1: show monitor session Example #2: show port allExample #3: show port interface

Use this command for a specific port. The output shows whether the port is the mirror or the probe

(Netgear Switch Routing) #show monitor session 1
Session ID Admin Mode Probe Port Mirrored Port
---------- ---------- ---------- -------------
1 Enable 1/0/8 1/0/7

Note: Monitor session ID “1” - “1” is a hardware limitation.

(Netgear Switch Routing) #show port all
Admin Physical Physical Link Link LACP
Intf Type Mode Mode Status Status Trap Mode
---- ---- ------ -------- ------- ------ ---- ----
1/0/1 Enable Auto Down Enable Enable
1/0/2 Enable Auto Down Enable Enable
1/0/3 Enable Auto Down Enable Enable
1/0/4 Enable Auto Down Enable Enable
1/0/5 Enable Auto Down Enable Enable
1/0/6 Enable Auto Down Enable Enable
1/0/7 Mirror Enable Auto Down Enable Enable
1/0/8 Probe Enable Auto Down Enable Enable
1/0/10 Enable Auto Down Enable Enable