NETGEAR 7000 Series manual Example #2 permit any

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

Example #2: permit any

(Netgear Switch) (Config-mac access-list)#permit ?

<srcmac>	Enter a MAC	address.
any	Configure a	match condition for all the destination MAC
	addresses in the Destination MAC Address field.

(Netgear Switch) (Config-mac access-list)#permit any ?

<dstmac>	Enter a MAC	address.
any	Configure a	match condition for all the destination MAC
	addresses in the Destination MAC Address field.

(Netgear Switch) (Config-mac access-list)#permit any any ?

assign-queue	Configure	the Queue Id assignment attribute.
cos	Configure	a	match condition based on a CoS value.
<ethertypekey>	Enter one	of the following keywords to specify an Ethertype
	(appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast,
<0x0600-0xffff)	netbios, novell, pppo, rarp).
	Enter a four-digit hexadecimal number in the range of 0x0600 to
vlan	0xffff to specify a custom Ethertype value.
	Configure a		match condition based on a VLAN ID.
<cr>	Press Enter		to execute the command.
(Netgear Switch)	(Config-mac		access-list)#permit any any

Access Control Lists (ACLs) 9-39

v1.0, May 2008