NETGEAR 7000 Series manual Protected Ports V1.0, May

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

.

Figure 25-1

The example is shown as CLI commands and as a Web interface procedure.

CLI Commands

To use the CLI to configure a protected port in order to isolate ports, enter the following CLI commands:

Step 1: Create one VLAN 192	including PC1 and PC2.
(Netgear Switch) #vlan database
(Netgear Switch) #vlan 192
(Netgear Switch) #vlan routing 192
(Netgear Switch) #exit
(Netgear Switch) #configure
(Netgear Switch) (Config)#interface 1/0/23
(Netgear Switch) (Interface 1/0/23)#vlan		pvid 192
(Netgear Switch) (Interface 1/0/23)#vlan		participation include 192
(Netgear Switch) (Interface 1/0/23)#exit
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#vlan		pvid 192
(Netgear Switch) (Interface 1/0/24)#vlan		participation include 192
(Netgear Switch) (Interface 1/0/24)#exit
(Netgear Switch) (Interface-vlan 192)#interface vlan 192
(Netgear Switch) (Interface-vlan 192)#routing
(Netgear Switch) (Interface-vlan 192)#ip		address 192.168.1.254 255.255.255.0
(Netgear Switch) (Interface-vlan 192)#exit
25-2		Protected Ports

v1.0, May 2008