NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

CLI Examples

This diagram shows a Layer 3 switch configured for port routing. It connects three different subnets, each connected to a different port. The script shows the commands you would use to configure a 7000 Series Managed Switch to provide the port routing support shown in the diagram.

Figure 7-1

Example #1: Enabling routing for the Switch

Use the following command to enable routing for the switch. Execution of the command enables IP forwarding by default.

(Netgear Switch) #config

(Netgear Switch) (Config)#ip routing (Netgear Switch) (Config)#exit

IP Routing Services

7-3

v1.0, May 2008

Page 53
Image 53
NETGEAR 7000 Series manual CLI Examples, Example #1 Enabling routing for the Switch