NETGEAR 7000 Series manual Example #4 Config monitor session 1 mode

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

port, and what is enabled or disabled on the port.

(Netgear	Switch	Routing) #show port 0/7
Intf	Type	Admin	Physical	Physical	Link	Link	LACP
		Mode	Mode	Status	Status	Trap	Mode
1/0/7	Mirror	Enable	Auto		Down	Enable	Enable
(Netgear	Switch	Routing) #show port 0/8
Intf	Type	Admin	Physical	Physical	Link	Link	LACP
		Mode	Mode	Status	Status	Trap	Mode
----	----	------	--------	--------	------	----	----
1/0/8	Probe	Enable	Auto		Down	Enable	Enable

Example #4: (Config) monitor session 1 mode

To set up port mirroring, specify the monitor session, then the mode.

(Netgear Switch Routing)(Config)#monitor?

session Configure port mirroring.

(Netgear Switch Routing)(Config)#monitor session?

<1-1> Session number.

(Netgear Switch Routing)(Config)#monitor session 1?

destination		Configure the probe interface.
mode	Enable/Disable port mirroring session.
source	Configure the source interface.

(Netgear Switch Routing)(Config)#monitor session 1 mode?

<cr> Press Enter to execute the command.

(Netgear Switch Routing)(Config)#monitor session 1 mode

Port Mirroring 17-3

v1.0, May 2008