NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

Process

To configure ACLs, follow these steps:

Create an ACL by specifying a name (MAC ACL) or a number (IP ACL)

Add new rules to the ACL

Configure the match criteria for the rules

Apply the ACL to one or more interfaces

IP ACL Examples

Example #1: Set up an IP ACL with Two Rules

The script in this section shows you how to set up an IP ACL with two rules, one applicable to TCP traffic and one to UDP traffic. The content of the two rules is the same. TCP and UDP packets will only be accepted by the 7000 Series Managed Switch if the source and destination stations have IP addresses that fall within the defined sets.

Figure 9-1

The following is an example of configuring ACL support on a 7000 Series Managed Switch.

Access Control Lists (ACLs)

9-3

v1.0, May 2008

Page 79
Image 79
NETGEAR 7000 Series manual Process, IP ACL Examples, Example #1 Set up an IP ACL with Two Rules