NETGEAR 7000 Series manual You power down or reset the networking device. In a stacking

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

Table 2-1. Quick Start Commands

Command	Mode	Description
copy system:run-	Privileged	Saves passwords and all other changes to the device.
ning-config	EXEC	If you do not save the configuration, all changes are lost when
nvram:startup-		you power down or reset the networking device. In a stacking
config
		environment, the running configuration is saved in all units of
		the stack.
logout	User EXEC	Logs the user out of the networking device.
	Privileged
	EXEC
show network	User EXEC	Displays the following network configuration information:
		• IP Address - IP Address of the interface (default: 0.0.0.0)
		• Subnet Mask - IP Subnet Mask for the interface (default:
		0.0.0.0)
		• Default Gateway - The default Gateway for this interface
		(default: 0.0.0.0)
		• Burned in MAC Address - The Burned in MAC Address used
		for in-band connectivity
		• Locally Administered MAC Address - Can be configured to
		allow a locally administered MAC address
		• MAC Address Type - Specifies which MAC address should
		be used for in-band connectivity
		• Network Configurations Protocol Current - Indicates which
		network protocol is being used (default: none)
		• Management VLAN Id - Specifies VLAN id
		• Web Mode - Indicates whether HTTP/Web is enabled.
		• Java Mode - Indicates whether java mode is enabled.
network parms	Privileged	Sets the IP address, subnet mask and gateway of the router. The
<ipaddr> <net-	EXEC	IP address and the gateway must be on the same subnet. IP
mask> [gateway]		address range is from 0.0.0.0 to 255.255.255.255.
copy nvram:star-	Privileged	Starts the configuration file upload, displays the mode and type
tup-config	EXEC	of upload and confirms the upload is progressing.
<tftp://<ipad-		The URL must be specified as:
dress>/<file-
		xmodem:<filepath>/<filename>
path>/<filename>>
		For example:
		If the user is using HyperTerminal, the user must specify where
		the file is going to be received by the PC.
2-12		Getting Started

v1.0, May 2008