NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

Example 2#: Manually Add a Host Name and an IP Address

The following example shows commands to add a static host name entry to the switch so that you can use this entry to resolve the IP address.

The example is shown as CLI commands and as a Web interface procedure.

CLI Commands

To use the CLI to manually add a host name and an IP address, enter the following CLI commands:

(Netgear Switch)#config

(Netgear Switch) (Config)#ip host www.netgear.com 206.82.202.46 (Netgear Switch) (Config)#ip domain-lookup

(Netgear Switch) (Config)#ping www.netgear.com

Send count=3, Receive count=3 from 206.82.202.46

Web Interface Procedure

To use the Web interface to manually add a host name and an IP address, proceed as follows:

1.From the main menu, select System > Management > DNS > Host Configuration. A screen similar to the following displays.

Figure 23-2

DNS

23-3

v1.0, May 2008

Page 187
Image 187
NETGEAR 7000 Series manual Example 2# Manually Add a Host Name and an IP Address