NETGEAR 7000 Series manual Example #2 show sntp client, Example #3 show sntp server

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

Example #2: show sntp client

(Netgear Switch Routing) #show sntp client

Client Supported Modes:		unicast broadcast
SNTP Version:		4
Port:		123
Client Mode:	Interval:	unicast
Unicast Poll		6
Poll Timeout	(seconds):	5
Poll Retry:		1

Example #3: show sntp server

(Netgear Switch Routing) #show sntp server

Server IP Address:	81.169.155.234
Server Type:	ipv4
Server Stratum:	3
Server Reference Id:	NTP Srv: 212.186.110.32
Server Mode:	Server
Server Maximum Entries:	3
Server Current Entries:	1
SNTP Servers
------------
IP Address:	81.169.155.234
Address Type:	IPV4
Priority:	1
Version:	4
Port:	123
Last Update Time:	MAY 18 04:59:13 2005
Last Attempt Time:	MAY 18 11:59:33 2005
Last Update Status:	Other
Total Unicast Requests:	1111
Failed Unicast Requests:	361

Example #4: Configure SNTP

Netgear switches do not have a built-in real-time clock. However, it is possible to use SNTP to get the time from a public SNTP/NTP server over the Internet. You may need permission from those public time servers. The following steps configure SNTP on the switch:

18-2 Simple Network Time Protocol (SNTP)

v1.0, May 2008