NETGEAR lldp receive, lldp timers, lldp transmit-tlv

Switching Commands
176
ProSafe M4100 and M7100 Managed Switches
lldp receive
Use this command to enable the LLDP receive capability.
Default
Format lldp receive
Mode
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Format no lldp receive
Mode
lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled
for LLDP. The <interval-seconds> determines the number of seconds to wait between
transmitting local data LLDPDUs. The range is 1-32768 seconds. The <hold-value> is the
multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier
range is 2-10. The <reinit-seconds> is the delay before re-initialization, and the range is
1-0 seconds.
Default • interval—30 seconds
• hold—4
• reinit—2 seconds
Format lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit
<reinit-seconds>]
Mode
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Format no lldp timers [interval] [hold] [reinit]
Mode
lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs. Use sys-name to transmit the system
name TLV. To configure the system name, see snmp-server on page 670. Use sys-descto
transmit the system description TLV. Use sys-cap to transmit the system capabilities TLV.
enabled
Interface Config
Interface Config
Global Config
Global Config