IPv6 Multicast Commands
426
ProSafe M4100 and M7100 Managed Switches
PIM Mode..................................... Dense
Data Threshold Rate (Kbps)................... 0
Register Rate-limit (Kbps)................... 0
Interface Interface Mode Operational-Status
--------- -------------- ----------------
0/1 Enabled Non-Operational
show ipv6 pim neighbor

Use this command to display the PIM neighbor information for all interfaces or for the

specified interface.

Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 pim neighbor 0/1
Interface Neighbor Up Time Expiry Time
Address (hh:mm:ss) (hh:mm:ss)
show ipv6 pim interface

Use this command to display PIM configuration information for all interfaces or for the

specified interface. If no interface is specified, configuration of all interfaces is displayed.

Format show ipv6 pim interface [<slot/port>|vlan]
Modes • Privileged EXEC
• User EXEC
Format show ipv6 pim neighbor [<slot/port>|vlan]
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Neighbor
Address The IP address of the neighbor on an interface.
Up Time The time since this neighbor has become active on this interface.
Expiry Time The expiry time of the neighbor on this interface.
DR Priority DR Priority configured on this interface (PM-SM only).
Term Definition
Mode Active PIM protocol.
Interface Interface number.