NETGEAR set garp timer leave, set garp timer leaveall

Switching Commands
72
ProSafe M4100 and M7100 Managed Switches
no set garp timer join
This command sets the GVRP join time (for one or all ports and per GARP) to the default and
only has an effect when GVRP is enabled.
Format no set garp timer join
Mode • Interface Config
• Global Config
set garp timer leave
This command sets the GVRP leave time for one port (Interface Config mode) or all ports
(Global Config mode) and only has an effect when GVRP is enabled. Leave time is the time
to wait after receiving an unregister request for a VLAN or a multicast group before deleting
the VLAN entry. This can be considered a buffer time for another station to assert registration
for the same attribute in order to maintain uninterrupted service. The leave time is 20–600
(centiseconds). The value 60 centiseconds is 0.6 seconds.
Default
Format set garp timer leave <20-600>
Mode • Interface Config
• Global Config
no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only
has an effect when GVRP is enabled.
Format no set garp timer leave
Mode • Interface Config
• Global Config
set garp timer leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order
to maintain registration. The value applies per port and per GARP participation. The time may
range from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds. You
can use this command on all ports (Global Config mode) or a single port (Interface Config
mode), and it only has an effect only when GVRP is enabled.
Default
Format set garp timer leaveall <200-6000>
Mode • Interface Config
• Global Config
60
1000