Switching Commands
28
ProSafe M4100 and M7100 Managed Switches
interface loopback
Use this command to enter the Interface Config mode for a loopback interface. The range of
the loopback ID is 0–7.
Format interface loopback <loopback-id>
Mode
no interface loopback
This command removes the loopback interface and associated configuration parameters for
the specified loopback interface.
Format no interface loopback <loopback-id>
Mode
show interface loopback
This command displays information about configured loopback interfaces.
Format show interface loopback [<loopback-id>]
Mode
If you do not specify a loopback ID, the following information appears for each loopback
interface on the system:
Loopback ID
Interface
IP Address
Received
Packets
Sent Packets
IPv6 Address
If you specify a loopback ID, the following information appears:
Global Config
Global Config
Privileged EXEC
Term Definition
The loopback ID associated with the rest of the information in the row.
The interface name.
The IPv4 address of the interface.
The number of packets received on this interface.
The number of packets transmitted from this interface.
The IPv6 address of this interface.
Term Definition
Interface Link
Status Shows whether the link is up or down.
IP Address The IPv4 address of the interface.
IPv6 is enabled
(disabled) Shows whether IPv6 is enabled on the interface.