NETGEAR ip dhcp snooping binding, ip verify binding, ip dhcp snooping limit

Switching Commands
134
ProSafe M4100 and M7100 Managed Switches
no ip dhcp snooping database write-delay
Use this command to set the write delay value to the default value.
Format no ip dhcp snooping database write-delay
Mode
ip dhcp snooping binding
Use this command to configure static DHCP Snooping binding.
Format ip dhcp snooping binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode
no ip dhcp snooping binding <mac-address>
Use this command to remove the DHCP static entry from the DHCP Snooping database.
Format no ip dhcp snooping binding <mac-address>
Mode
ip verify binding
Use this command to configure static IP source guard (IPSG) entries.
Format ip verify binding <mac-address> vlan <vlan id> <ip address> interface
<interface id>
Mode
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
Format no ip verify binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode
ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come. The
default rate is 15 pps with a range from 0 to 30 pps. The default burst level is 1 second with a
range of 1–15 seconds.
Global Config
Global Config
Global Config
Global Config
Global Config
Default 15 pps for rate limiting and 1 sec for burst interval