IPv6 Commands
358
ProSafe M4100 and M7100 Managed Switches
ipv6 hop-limit
This command defines the unicast hop count used in ipv6 packets originated by the node.
The value is also included in router advertisements. Valid values for <hops> are 1-255
inclusive. The default “not configured” means that a value of zero is sent in router
advertisements and a value of 64 is sent in packets originated by the node. Note that this is
not the same as configuring a value of 64.
Default
Format ipv6 hop-limit <hops>
Mode
no ipv6 hop-limit
This command returns the unicast hop count to the default.
Format no ipv6 hop-limit
Mode
ipv6 unicast-routing
Use this command to enable the forwarding of IPv6 unicast datagrams.
Default
Format ipv6 unicast-routing
Mode
no ipv6 unicast-routing
Use this command to disable the forwarding of IPv6 unicast datagrams.
Format no ipv6 unicast-routing
Mode
ipv6 enable
Use this command to enable IPv6 routing on an interface, including tunnel and loopback
interfaces, that has not been configured with an explicit IPv6 address. When you use this
command, the interface is automatically configured with a link-local address. You do not need
to use this command if you configured an IPv6 global address on the interface.
Default
Format ipv6 enable
Mode
not configured
Global Config
Global Config
disabled
Global Config
Global Config
disabled
Interface Config