IPv6 Commands
357
ProSafe M4100 and M7100 Managed Switches

tunnel mode ipv6ip

This command specifies the mode of the tunnel. With the optional 6to4 argument, the tunnel
mode is set to 6to4 automatic. Without the optional 6to4 argument, the tunnel mode is
configured.
Format tunnel mode ipv6ip [6to4]
Mode

show interface tunnel

This command displays the parameters related to tunnel such as tunnel mode, tunnel source
address, and tunnel destination address.
Format show interface tunnel [<tunnel-id>]
Mode
If you do not specify a tunnel ID, the command shows the following information for each
configured tunnel:
Tunnel ID
Interface
Tunnel Mode
Source Address
Destination
Address
If you specify a tunnel ID, the command shows the following information for the tunnel:
Interface Link
Status
MTU Size
IPv6 Prefix is
IPv6 Routing Commands
This section describes the IPv6 commands you use to configure IPv6 on the system and on
the interfaces. This section also describes IPv6 management commands and show
commands.
Interface Config
Privileged EXEC
Term Definition
The tunnel identification number.
The name of the tunnel interface.
The tunnel mode.
The source transport address of the tunnel.
The destination transport address of the tunnel.
Term Definition
Shows whether the link is up or down.
The maximum transmission unit for packets on the interface.
If you enable IPv6 on the interface and assign an address, the IPv6 address and prefix
display.