Routing Commands
264
ProSafe M4100 and M7100 Managed Switches
no network area (OSPF)
Use this command to disable the OSPFv2 on an interface if the IP address of an interface
was earlier covered by this network command.
Format no network <ip-address> <wildcard-mask> area <area-id>
Mode
ip ospf area
Use this command to enable OSPFv2 and set the area ID of an interface. The <area-id> is
an IP address formatted as a 4-digit dotted-decimal number or a decimal value in the range
of <0-4294967295>. This command supersedes the effects of the network area
command. It can also be used to configure the advertiseability of the secondary addresses
on this interface into the OSPFv2 domain.
Default
Format ip ospf area <area-id> [secondaries none]
Mode
no ip ospf area
Use this command to disable OSPF on an interface.
Format no ip ospf area [secondaries none]
Mode
1583compatibility
This command enables OSPF 1583 compatibility.
Note: 1583 compatibility mode is enabled by default. If all OSPF routers in
the routing domain are capable of operating according to RFC 2328,
OSPF 1583 compatibility mode should be disabled.
Default
Format 1583compatibility
Mode
Router OSPF Config
disabled
Interface Config
Interface Config
enabled
Router OSPF Config