Utility Commands
566
ProSafe M4100 and M7100 Managed Switches
no dns-server
This command removes the DNS Server list.
Format no dns-server
Mode
hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is the
MAC address of the hardware platform of the client consisting of 6 bytes in dotted
hexadecimal format. Type indicates the protocol of the hardware platform. It is 1 for 10 MB
Ethernet and 6 for IEEE 802.
Default
Format hardware-address <hardwareaddress> <type>
Mode
no hardware-address
This command removes the hardware address of the DHCP client.
Format no hardware-address
Mode
host
This command specifies the IP address and network mask for a manual binding to a DHCP
client. Address and Mask are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0 to 32.
Default
Format host <address> [{<mask> | <prefix-length>}]
Mode
no host
This command removes the IP address of the DHCP client.
Format no host
Mode
DHCP Pool Config
ethernet
DHCP Pool Config
DHCP Pool Config
none
DHCP Pool Config
DHCP Pool Config