Routing Commands
228
ProSafe M4100 and M7100 Managed Switches
no routing
This command disables routing for an interface.
You can view the current value for this function with the show ip brief command. The
value is labeled as “Routing Mode.”
Format no routing
Mode
ip routing
This command enables the IP Router Admin Mode for the master switch.
Format ip routing
Mode
no ip routing
This command disables the IP Router Admin Mode for the master switch.
Format no ip routing
Mode
ip address
This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface. The command supports
RFC 3021 and accepts using 31-bit prefixes on IPv4 point-to-point links. This command adds
the label IP address in show ip interface.
Note: The 31-bit subnet mask is only supported on routing interface. This
feature is not supported on a network port because it acts as a host,
not a router, on the management interface.
Format ip address <ipaddr> {subnetmask | /prefix-length} [secondary]
Mode
Format routing
Mode Interface Config
Interface Config
Global Config
Global Config
Interface Config