NETGEAR show ipv6 ospf

IPv6 Commands
398
ProSafe M4100 and M7100 Managed Switches
• To enable all the flags, give the command as trapflags all.
Default
Format trapflags {
all |
errors {all | authentication-failure | bad-packet | config-error |
virt-
authentication-failure | virt-bad-packet | virt-config-error} |
if-rx {all | if-rx-packet} |
lsa {all | lsa-maxage | lsa-originate} |
overflow {all | lsdb-overflow | lsdb-approaching-overflow} |
retransmit {all | packets | virt-packets} |
rtb {all, rtb-entry-info} |
state-change {all | if-state-change | neighbor-state-change |
virtif-state-
change | virtneighbor-state-change}
}
Mode
no trapflags(OSPFv3)
Use this command to revert to the default reference bandwidth.
• To disable the individual flag, enter the group name followed by that particular flag.
• To disable all the flags in that group, give the group name followed by all.
• To disable all the flags, give the command as trapflags all.
show ipv6 ospf
This command displays information relevant to the OSPF router.
Format show ipv6 ospf
Mode
disabled
Router OSPFv3 Config
Format no trapflags {
all |
errors {all | authentication-failure | bad-packet | config-error |
virt-
authentication-failure | virt-bad-packet | virt-config-error} |
if-rx {all | if-rx-packet} |
lsa {all | lsa-maxage | lsa-originate} |
overflow {all | lsdb-overflow | lsdb-approaching-overflow} |
retransmit {all | packets | virt-packets} |
rtb {all, rtb-entry-info} |
state-change {all | if-state-change | neighbor-state-change |
virtif-state-
change | virtneighbor-state-change}
}
Mode Router OSPFv3 Config
Privileged EXEC