NETGEAR IP Address Conflict Commands

Utility Commands
610
ProSafe M4100 and M7100 Managed Switches
(Managed Switches) #
show license features
This command displays the features that are licensed on the switch
Format show license features
Mode
Example: The following shows example CLI display output for the command.
(Managed Switches) #show license features
IGMP
MCAST
PIMDM
DVMRP
PIMSM
OSPFV3
IPV6
IP Address Conflict Commands
ip address-conflict-detect run
This command triggers the switch to run active address conflict detection by sending
gratuitous ARP packets for IPv4 addresses on the switch.
Note: This command takes effect only once after it is executed and cannot
be saved across power cycles.
Format ip address-conflict-detect run
Mode
show ip address-conflict
This command displays the status information corresponding to the last detected address
conflict.
Privileged EXEC
Global Config
Term Definition
Address
Conflict
Detection
Status
Identifies whether the switch has detected an address conflict on any IP address.
Last Conflicting
IP Address The IP Address that was last detected as conflicting on any interface.