Orbit Manufacturing 2000 manual Plate holders

Operations Orbit™ 2000 Operation and Maintenance Manual

Plate holders

The plate holders keeps the paper sheet on the lower guiding plate to prevent it from jumping over the second gate.

Positioning: The machine has three hold-down fingers in total. The position of the middle one does not change and is factory set. The position of the extreme two change with respect to the size of sheet, and is adjusted to be about 10 mm distant from the edge of paper, after the screw ( h ) has been loosened. Be sure to tighten the screw ( h ) after positioning the hold down fingers.

10

10

Adjusting: Pressure is adjusted by moving the holder ( i ) , which is held by screw ( j ). Follow the procedure below.

1/

2/

3/

4/

Loosen the screw ( h ).

Insert one sheet of paper ( of the same

specific weight ) to be laminated.

Adjust the holders so the finger ( k )

touches the paper without bending.

Tighten the screw ( h ).

j

P re s s u re are a

k

h

i

F ee d er

Page 5 - 18 © GBC Films Group January 2001