Obit™ 2000 Operation and Maintenance Manual | Troubleshooting | |
|
|
|
(2) Symptom: | The light in the start button is off. |
|
Possible causes: | – Check the Lucite cover over the chrome roller is closed. |
|
| – Check the Lucite cover over the separator is closed. |
|
| – Check the side door under the control panel is closed. |
|
| – Check all emergency push buttons are in the released ( up ) position. | |
| – Check that the paper in the feeder is not too high where the microswitch is pressed. |
(3) Symptom: | The machine is running, then suddenly stops. |
Possible causes: | – Check for a green light in the start button. ( if not start at that symptom ) |
| – A sheet of paper switched off the microswitch on the feeding head. |
(4) Symptom: | The machine was running, suddenly stopped and cannot be |
| restarted again. The red LED located in the electrical cabinet is not |
| illuminated. |
Possible causes: | – The paper pile moved upwards causing the emergency microswitch on the feeding |
| head to be depressed. |
(5) Symptom: | When the sheet size is changed, the feeding head feeds the sheets |
| irregularly or the sheet stays on the paper pile |
Possible cause: | – The reason for this may be the suction cups that overlap the paper width and suck |
| air from where there is no paper. By turning the cup the suction orifice in the |
| suction bar is closed. |
| – Check vacuum on the manometer above the feeding head. |
© GBC Films Group January 2001 | Page 7 - 13 |