6. Click OK.
The HotSync Manager is now communicating with the simulated port defined for infrared communication. This means that you cannot use your HotSync cradle/cable again until you reconfigure the HotSync Manager to communicate with the port defined for cradle/cable synchronization.
To configure HotSync Manager for infrared communication on a Macintosh:
1.
2.In the HotSync Controls tab, select Enabled.
3.Click the Serial Port Settings tab.
4.Under Check for handheld connection using, select Local Setup.
5.Under Local Setup, select Infrared Port from the Port
6. Close the HotSync Software Setup window.
Page 135 | Advanced HotSync® Operations |
