Panasonic KX-FG6550 operating instructions Cordless handset

10. Help

Problem	Cause & Solution
The ink film runs out	L Even if there are only a few sentences, every page that comes out
quickly.	of the machine is considered a full page.
	L Turn OFF the following features:
	– confirmation report: feature #04 on page 79.
	– journal report: feature #22 on page 80.
	– Caller ID list: feature #26 on page 81.
The unit beeps.	L Recording paper/ink film has run out. Press {STOP} to stop the
	beeps and install paper/ink film.
Whenever I try to retrieve	L You are probably entering {*}{#}{9}. This is the default setting
my voice mail messages, I	for the fax activation code. If you use a voice mail service, turn the
am interrupted by the fax	fax activation feature OFF or reprogram the activation code
tone.	(feature #41 on page 82).
The speakerphone is not	L Use the speakerphone in a quiet room.
working.	L If you have difficulty hearing the other party, adjust the volume.
I cannot page the handset	L The called handset is too far from the base unit.
or base unit.	L The called unit is in use. Try again later.
	L If more than one other user is using the handsets and base unit,
	you may not be able to page. Try again later.
The {AUTO ANSWER}	L This button does not function during conference calls. Wait for the
button does not function	call to end, and try again.
properly.
The unit does not display	L You need to subscribe to a Caller ID service.
the caller’s name and/or	L Other telephone equipment may be interfering with your phone.
telephone number.	Disconnect it and try again.
	L Other electrical appliances connected to the same outlet may be
	interfering with the Caller ID information.
	L Telephone line noise may be affecting the Caller ID information.
	L The caller requested not to send his/her information (page 44).
	L If a call is being transferred to you, the caller information will not be
	displayed.
The Caller ID list/incoming	L The Caller ID number auto edit feature is turned OFF. Turn it ON
phone numbers are not	and try again (page 47).
edited automatically.
The display exits the	L Do not pause for over 1 minute on the handset or 3 minutes on the
Caller ID List while	base unit while searching.
viewing caller
information.
10.3.3 Cordless handset
Problem	Cause & Solution
The handset does not	L Make sure that the battery is installed correctly (page 18).
work.	L Fully charge the battery (page 23).
	L Clean the charge contacts and charge again (page 23).
	L Unplug the base unit’s power cord and the handset’s AC adaptor to
	reset. Plug in, and try again.
	L The handset has not been registered to the base unit. Register the
	handset (page 92).
	L Re-install the battery (page 18) and fully charge it.

100For assistance, please visit http://www.panasonic.com/consumersupport