RAD Data comm IPmux-16 To set the Authentication/Community parameters, Host Configuration

IPmux-16Installation and Operation Manual Chapter 3 Operation

➤To set the Authentication/Community parameters:

Main Menu

↓

2. Configuration

↓

1.General Configuration

↓

2.Host

Configuration

1.Enter 1 to set the authentication-failure trap: On or Off. Use the Spacebar to toggle between these two settings. When this parameter is set to On, an authentication-failure trap is generated when a system manager attempts to set a parameter within IPmux-16 with an incorrect community value.

2.Enter 2 to name the trap community: Enter a name of up to 10 alphanumeric characters. The entry is case-sensitive.

3.Enter 3 to name the read community: Enter a name of up to 10 alphanumeric characters. The entry is case-sensitive.

4.Enter 4 to name the write community: Enter a name of up to 10 alphanumeric characters. The entry is case-sensitive.

Host Configuration

➤To configure the Host IP:

•Type 2 ( Host Configuration) in the General Configuration menu.

The device must be configured with the HOST IP and Mask in order to combine the IP packet (source IP Add). This Host IP is also necessary for the inband management capability of IPmux-16.

Note Frames will not leave the device until IP and Mask addresses are defined.

	HOST CONFIGURATION
1.	Host Index	1
2.	IP Address	192.168.100.1
3.	IP Mask	255. 255.	255. 0
ESC. Exit		D. Delete
Select item from the menu:_
Use <ESC> key or keys <1> to <3>

Figure 3-14. User Port Configuration Menu

➤To change the Host ID configuration:

1. Select D.

A confirmation message is displayed “Configuration would be deleted! Are you sure? (Y/N)”.

2. Press Y.

A second confirmation message appears “Bundle connections, Default GW and Managers IP's will be deleted (Y/N)”.

Configuring IPmux-16 3-13