Chapter 3 OperationIPmux-16Installation and Operation Manual
Bundle Connection Configuration
Main Menu | ➤ To view and configure Bundle Connection parameters: |
↓ | |
2. Configuration | • Type 3 (Bundle Connection Configuration) in the Configuration menu. |
↓ |
|
3.Bundle Connection
Configuration
| BUNDLE CONNECTION CONFIGURATION |
|
1. | DS0 Bundle ID | 1 |
2. | Connection Status | Enable |
3. | Destination IP Address | 10.10.10.10 |
4. | Next Hop | 192.168.238.1 |
5. | Destination Bundle | 1 |
6. | Jitter Buffer (x10 usec) | 300 |
7. | TDM bytes in frame | 48 |
ESC. Exit |
| D. Delete | N. Next |
SYSTEM USAGE: | 6.25 | % | |
Select item from | the menu. |
| |
Use | keys | <1> to <7> | |
Figure 3-32. Bundle Connection Configuration
Parameters must be configured for each connection. To configure all parameters, first select the bundle ID and then proceed with the parameter configuration.
➤To set the source DS0 Bundle ID:
1.Type 1.
2.Type in the bundle ID: 1 to 496. Note The bundle should be defined first.
➤To set the Connection Status:
1.Type 2.
2.Use the <Spacebar> on your keyboard to toggle between Enable and Disable.
When set to Disable, frames will not be sent on this connection.
➤Destination IP Address
1.Type 3.
2.Enter the IP address of the destination device
