120
Chapter 8 EZ Routing
6. Only the sources—Input Mixer Channels and Track
Mixer Channels—you specified during Step 5 will be
shown. Use [ ], [ ], [ ], and [ ] to move
the cursor and the TIME/VALUE dial to adjust each of
the values.
fig.02-26
7. Press [F2 (STEP →)]. You can return to the previous
screen by pressing [F1 (STEP ←)].
8. Make the settings for the effects. Use [ ], [ ],
[ ], and [ ] to move the cursor and the TIME/
VALUE dial to adjust each of the values. Press [F3 (FX
A)] to make settings to EFFECT A (FX1/2); press [F4 (FX
B)] to make settings to EFFECT B (FX3/4).
fig.02-27
9. Press [F2 (STEP →)]. You can return to the previous
screen by pressing [F1 (STEP ←)].
10.Select mixer channels to be output to the AUX bus. The
AUX bus is useful for sending tracks to an external
effects processor. Use [ ], [ ], [ ], and [ ]
to move the cursor and the TIME/VALUE dial to adjust
each of the values.
fig.02-28
11.Press [F2 (STEP →)]. You can return to the previous
screen by pressing [F1 (STEP ←)].
12.Select the Master Section settings. Use [ ], [ ],
[ ], and [ ] to move the cursor and the TIME/
VALUE dial to adjust each of the values.
fig.02-29
13.Press [F4 (Exec)]. “EZ ROUTING Step Edit is finished!!”
appears in the display.
fig.02-24a
WARNING: EZ Routing settings will override any existing
mixer settings you have already made.
14.You can save your setup as an EZ Routing template, or
Exit [F6 (EXIT)] to leave this display without saving. To
save the setup, press [F3 (SAVE)]. The Routing Save
screen appears in the display. Save the setup using the
procedure described in “Saving an EZ Routing
Template,” p. 123.
Cursor Pan
Level
Track Channel
Effect Switch
Send Level
Send Pan
Cursor
AUX Switch
AUX Send Switch
AUX Send Pan/
Balance
Cursor
Input Channel Track Channel
Monitor Select
Equalizer Mode
Direct Out
Effect Insert
CDR Recording
Mode
Destination V-Track