[F3 (Solo)] SOLO

Use this to turn the SOLO function on and off for a mixer

channel.

[F4 (Mute)] MUTE

Use this to turn the MUTE function on and off for a mixer

channel.

[F5 (Fader)] FADER

Controls the level (0-127) of the signal.

Chapter 6 Mixer Channel Strip Detail

Master Block

The following functions are found in the Master Block section of the mixer. Press [EDIT/SOLO] to view and adjust the settings of the Master Block. Press the function button located under the display corresponding to the setting you

wish to change. Or, press [ ], [ ], [ ], and [ ] to move the cursor to the setting you wish to change. Use the TIME/VALUE dial to select the desired value.

If you adjust the pan while sound is playing, you may notice “blips” in the sound. This is not a malfunction. If you find it annoying, adjust the pan when the sound is not playing.

[F1 (MST)] MASTER

Adjusts the level and balance of the master mix.

Level

This adjusts the volume level (0-127) for the MASTER OUT

jacks. This is normally adjusted using the Master fader.

Balance

This adjusts the left-right balance (L63-R63) for the MASTER

OUT jacks.

[F2 (MON)] MONITOR

Adjusts the level and balance of the Monitor mix.

Level

This adjusts the volume level (0-127) for the MONITOR jack.

This is normally adjusted using the MONITOR knob on the

top panel.

Balance

This adjusts the left-right balance (L63-R63) for the

MONITOR jacks.

[F3 (AUX.A)] AUX A

This selects the signal to be assigned to the AUX A jacks.

FX1:

The signal at the EFFECT 1 bus.

FX2:

The signal at the EFFECT 2 bus.

AUX1/FX3:

The signal at the AUX1 bus, or, when a second VS8F-2 Effect

card is installed in the VS-1824, the EFFECT 3 bus.

AUX2/FX4:

The signal at the AUX2 bus, or, when a second VS8F-2 Effect

card is installed in the VS-1824, the EFFECT 4 bus.

AUX3/AUX:

The signal at the AUX3 bus, or, when a second VS8F-2 Effect

card is installed in the VS-1824, the AUX bus.

Chapter 6

95

Page 95
Image 95
Roland VS-1824 owner manual Master Block, F3 AUX.A AUX a