Roland VS-1824 owner manual Determining Output, Monitor Output Connectors, Mon Monitor

Chapter 5 Using the Digital Mixer

Determining Output

The VS-1824 has eight analog output jacks and two stereo digital outputs. Each of these outputs can have various signals assigned to them. Use the following procedure to determine the signal for each output jack or connector.

MONITOR Output Connectors

1.Press [EDIT/SOLO]. The Master Block is displayed.

2.Use [ ], [ ], [ ], and [ ] to move the cursor to “OUTPUT (MON).” Use the TIME/VALUE

dial to adjust the setting.

3.Press [F2(Mon)]. If “Mon” does not appear above [F2], press [PAGE] until “Mon” appears above [F2], and then press [F2(Mon)].

Level

Balance

Level

This adjusts the volume level (0-127) for the MONITOR jack. This is normally adjusted using the MONITOR knob on the top panel.

Balance

This adjusts the left-right balance (L63-R63) for the MONITOR jacks.

4.Press [PLAY (DISPLAY)] to return to the Playlist display.

Mon (Monitor)

This selects what signal is to be assigned to the MONITOR jacks.

MST:

The signal at the MASTER jacks (MIX bus).

FX1:

The signal at the EFFECT 1 bus.

FX2:

The signal at the EFFECT 2 bus.

AUX1/FX3:

The signal at the AUX1 bus, or EFFECT 3—the EFFECT 3 bus—when a second VS8F-2 effect card is installed in the VS-1824.

AUX2/FX4:

The signal at the AUX2 bus, or EFFECT 4—the EFFECT 4 bus—when a second VS8F-2 effect card is installed in the VS-1824.

AUX3/AUX:

The signal at the AUX3 bus, or AUX—the AUX bus— when a second VS8F-2 Effect card is installed in the VS-1824.

REC:

The signal at the RECORDING bus.

ST IN:

The signal assigned to the STEREO IN.

72