Changing settings of the Track Mixer Buttons and Faders (Fader Mode)

You can switch the panel buttons and faders that are used to affect each Track Mixer channel.

1.Press [PLAY (DISPLAY)].

2.Hold [SHIFT] and press [F5 (SYSTEM)].

The System menu icon appears in the display.

If the System menu does not appear, press [F6 (EXIT)].

3.Press [F1 (SYSPM)].

If “SYSPM” does not appear above [F1], press [PAGE] until “SYSPM” appears, then press [F1 (SYSPM)].

4.Using [ ], [ ], [ ], and [ ], select “Fader Mode.” If “Fader Mode” does not appear in the display, press [F1 (Prm 1)].

Fader Mode

Used for specifying the correspondence or assignment of panel buttons and faders to each of the Track Mixer channels.

VS-1824:Assignments are as indicated on the panel.

Chapter 5 Using the Digital Mixer

Mixer Routing

Sources Assigned to Tracks

In a newly created song, inputs are assigned to tracks as shown below. This is the default mixer routing.

Using the STATUS and SELECT buttons, it is possible to set up almost any type of routing. To determine the source(s) assigned to a track for recording, use the following procedure.

When “VS-1880” is selected as the fader mode (p. 75), inputs

are assigned to tracks as shown below.Chapter 5

VS-1880:Assignments are according to the overlay sheet provided with the workstation.

5.Press [PLAY (DISPLAY)] to return to the Playlist display.

75

Page 75
Image 75
Roland VS-1824 owner manual Mixer Routing, Sources Assigned to Tracks, Fader Mode