Roland VS-1824 owner manual Preparations for Compu Mix, 266

Chapter 22 Specific Applications

Controller numbers correspond to the input channel parameters as follows.

Controller Number	Mixer Parameter
68	MIX Send Level

70MIX Send Pan

71EQ L Freq.

72EQ L Gain

73EQ M Freq.

74EQ M Gain

75EQ M Q

76EQ H Freq.

77EQ H Gain

78FX1 SND Level

79FX1 SND Pan/Balance

80FX2 SND Level

81FX2 SND Pan/Balance

82AUX1 (* FX3) SND Level

83AUX1 (* FX3) SND Pan/Balance

84AUX2 (* FX4) SND Level

85AUX2 (* FX4) SND Pan/Balance

86AUX3 (* AUX) SND Level

87AUX3 (* AUX) SND Pan/Balance

88MIX Offset Level

89MIX Offset Balance

*When you are installing two effect expansion boards.

Controller numbers correspond to the Master Block parameters as follows.

Controller Number	Mixer Parameter
68	Master Level
70	Master Balance
78	FX1 SND Level
79	FX1 SND Balance
80	FX2 SND Level
81	FX2 SND Balance
82	AUX1 (* FX3) SND Level
83	AUX1 (* FX3) SND Balance
84	AUX2 (* FX4) SND Level
85	AUX2 (* FX4) SND Balance
86	AUX3 (* AUX) Level
87	AUX3 (* AUX) Balance

102Monitor Level

103Monitor Balance

*When you are installing two effect expansion boards.

Preparations for Compu Mix

1.Make connections as shown below.

MIDI OUT MIDI OUT

MIDI Sequencer

2.Hold [SHIFT] and press [F5 (SYSTEM)]. The System Menu appears in the display.

If the System Menu does not appear, press [F6 (EXIT)].

3.Press [F4 (MIDI)]. If “MIDI” does not appear above [F4], press [PAGE] until “MIDI” appears, then press [F4 (MIDI)].

4. Use [ ], [ ], [ ], and [ ] to move the

cursor and use the TIME/VALUE dial to make settings for each parameter as described below.

MIDI Thru (MIDI Thru Switch)

For this application, set this to “OUT.”

Cntrl Local (Control Local Switch)

For this application, set this to “On.”

Control Type (Mixer Control Types)

For this application, set this to “C.C.”

5.Follow the procedure described in “Synchronizing with MIDI Sequencers” (“Synchronizing with MIDI Sequencers,” p. 197) to make the necessary settings in both the VS-1824 and the MIDI sequencer to synchronize the two machines. Make sure to set the MIDI sequencer so MIDI messages received at the MIDI In connector are not output from the MIDI Out connector.

266