Roland VS-1824 owner manual Capture Audio data from Audio CD Capture function

Capture Audio data from Audio CD (Capture function)

VS-1824 have function to capture Audio data from Audio CDs.

This can capture audio from CD only in case the

sampling rate setting of current song is 44.1kHz.

If you are using a VS-1824 that is not equipped with an internal CD-RW drive, you will need to purchase a separately available CD-RW drive.

For instructions on connecting the drive, refer to “Connecting an External CD-R/CD-RW Drive” (Owner’s Manual p. 192).

PX-4220Te, PX-8220Te, PX-W124TSe, and PX-W1210TSE manufactured by PLEXTOR is supported. In case you are using other drives approved by Roland, consult with your retailer, the nearest Roland Service Center, or an authorized Roland distributor.

1.Load an Audio CD or CD-R/RW disc that contains audio you like to capture on CD-RW drive.

2.Press [CD-RW/MASTERING]. CD-RW/Mastering Menu will appear.

3.Press [F6 (CDCap].

CD Capture screen will appear.

4.Press [ ][ ][ ][ ]to move curser and set each of following parameters using TIME/VALUE dial.

If following cases, the tracks to capture audio must be set as Stereo Pair. In case it is not set as Stereo Pair, a message of “Illegal Track Pair!” appears and unable to capture audio.

•“CDR” is selected as recording mode of the current song.

•Any phrases in CD-R mode is recorded in destination tracks.

●L-Ch Dest Track (L channel destination track)

Select the destination track of audio to capture. Select the destination track of left channel audio here.

●R-Ch Dest Track (R channel destination track)

Select the destination track of audio to capture. Select the destination track of right channel audio here.

*In case the track which contain any phrases in CD-R mode is selected as destination of “L-Ch Dest Track,” it is impossible to change “R-Ch Dest Track” with TIME/VALUE dial.

●Capture TO

You can adjust the time of placement. to ZERO:

Place the audio data starting at 00h00m00s00f. to Last Phrs:0S:

Place the audio data after the end of the last phrase in the destination tracks.

to Last Phrs:2S:

Place the audio data two seconds after the end of the last phrase in the destination tracks.

to Last Phrs:4S:

Place the audio data four seconds after the end of the last phrase in the destination tracks.

5.Once the above parameters are set, select the track of CD shown under “CD Track” pressing [PREVIOUS] or [NEXT]. The highlighted track is the target to capture.

●CD Track

Select the track of CD shown under “CD Track.”

Press [PLAY] to play the highlighted track.

When the cursor is in list of “CD Track,” you can select track

of CD pressing [ ][ ].