Roland VS-1824 owner manual Adding a Song to a Partially Recorded Disc, 190

Chapter 13 CD-RW and Mastering

13.Press [F5 (Exec)].

A message will ask you to confirm.

When you are using CD-RW discs:

“Track at Once” cannot be selected as the writing mode for “Writing Method.” The following message appears on the LCD and it will be unable to carry out the operation if you try to write CD-RW discs using the Track at Once method.

In this case, press [ENTER/YES].

14.“Audio CD-R Write Sure ?” and “CD Track No. OK?” appears in the display. This message confirms the Finalize setting, and makes sure CD track markers are set. Press [ENTER/YES], or to cancel the operation, press [EXIT/NO].

15.A message regarding copyright appears in the display. After reading this message carefully, if you agree to the conditions, press [ENTER/YES]. To cancel, press [EXIT/NO].

16.A message regarding licensing conditions appears in the display. After reading this message carefully, if you agree to the conditions, press [ENTER/YES]. To cancel the operation, press [EXIT/NO].

If “Not 44.1kHz Song !” Appears in the Display

The sample rate is not 44.1 kHz, so the song cannot be written to the CD-R disc. Press [YES/ENTER] to cancel the procedure. Please refer to “Create a New Song (Song New),” p. 50. Make sure to use 44.1 kHz sample rate for songs to be recorded to the CD-R/CD-RW drive.

If “Please Insert Disc!” Appears in the Display

This indicates the CD-R/CD-RW drive loading tray is open, that there is no disc loaded, or the CD-R/CD-RW drive is not ready for use. Insert a CD-R disc, wait a few moments for the CD-R drive to read the disc, and then press [ENTER/YES].

17.After the CD-R writing is finished, “Write Another ?” appears in the display. If you want to write the same track data to another CD-R disc, place a new disc in the CD-R/CD-RW drive and press [ENTER/YES]. Press [EXIT/NO] to return to Step 2.

Adding a Song to a Partially Recorded Disc

You can add new songs to a CD-R disc that has not been finalized. Repeat the procedure described in “Writing Songs to CD-R Discs,” p. 188. Approximately two seconds of silence is inserted between the new song and the song before it. The track number is recorded automatically.

		Track Number
Previous Song			Added Song
	Silent Portion (approx. 2 sec.)

Arranging and Recording Multiple Songs to a CD-R Disc

By sequencing a number of different songs on stereo tracks, you can arrange these songs and write them to a CD-R disc. You can program CD track numbers by placing CD track markers at song boundaries.

00h00m00s00

Song 1

Before Marker Setting Time

00h00m00s00
	Marker 1	Marker 2	Marker 3
Song 1	Song 2		Song 3
	After Marker Setting		Time

190