Chapter 13 CD-RW and Mastering

Canceling the capture

If you want to cancel capture in the middle, operate as follows.

1.Press [EXIT/NO]

A message “Abort?” appears.

2.Press [ENTER/YES] to cease capture. Press [EXIT/NO] to re-start capture.

Capturing Time

Capturing time differs according to recording mode as follows.

Recording Mode

CDR (CD writing) ....

Approx 40% of actual time

MAS (Mastering)

Approx 80% of actual time

Others

Approx 150% of actual time

 

 

Connecting an external CD-R/CD-RW Drive

*To prevent malfunction and or damage to speakers or other devices, always turn down the volume and turn off the power on all devices before making any connections.

1.Make sure both the VS-1824 and the CD-R/CD-RW drive are off. Connect the CD-R/CD-RW drive to the VS-1824 as shown below. If the CD-R is the only SCSI device connected to the VS-1824, or if it is the last device in the chain, make sure that the terminator plug is connected to the remaining SCSI port on the CD-R.

2.Turn on the power of the CD-R/CD-RW drive.

0

3.Turn on the power of the VS-1824.

*In order for the VS-1824 to properly recognize the CD-R/CD- RW drive upon boot-up, it is very important to turn the CD- R/CD-RW drive on first, and then turn on the VS-1824.

4.Turn on the power of connected audio equipment.

5.Raise the volume of the audio devices as desired.

194

Page 194
Image 194
Roland VS-1824 Connecting an external CD-R/CD-RW Drive, CD-RW and Mastering Canceling the capture, Capturing Time, 194