115
Chapter 8 EZ Routing
Chapter 8
8. Make the settings for the effects.
Use [ ], [ ], [ ], and [ ] to move the
cursor and the TIME/VALUE dial to adjust each of the
values. Press [F3 (FX A)] to make settings to EFFECT A
(FX1/2); press [F4 (FX B)] to make settings to EFFECT B
(FX3/4).
fig.02-21
9. Press F2 (STEP →)]. You can return to the previous
screen by pressing [F1 (STEP←)].
10.Decide whether or not to record the output of each effect
to a track. First, press the Effect SELECT button for Effect
1 or Effect 2, then press the STATUS button for the track
you want the effect recorded on. To select FX 3 or FX 4,
hold [SHIFT] and press the Effect SELECT button.
fig.02-22
11.Press [F2 (STEP →)]. You can return to the previous
screen by pressing [F1 (STEP←)].
12.Select mixer channels to be output to the AUX bus.
The AUX bus is useful for creating a separate headphone
mix for the performer you are recording. Use [ ],
[ ], [ ], and [ ] to move the cursor and the
TIME/VALUE dial to adjust each of the values.
fig.02-23
13.Press [F2 (STEP →)]. You can return to the previous
screen by pressing [F1 (STEP←)].
14.Select the Master Section settings.
Use [ ], [ ], [ ], and [ ] to move the
cursor and the TIME/VALUE dial to adjust each of the
values.
fig.02-24
15.Press [F4 (Exec)]. “EZ ROUTING Step Edit is finished!!”
appears in the display.
WARNING: EZ Routing settings will override any existing
mixer settings you have already made.
16.You can save your setup as an EZ Routing template, or
Exit [F6 (EXIT)] to leave this display without saving. To
save the setup, press [F3 (SAVE)]. The Routing Save
screen appears in the display. Save the setup using the
procedure described in “Saving an EZ Routing
Template,” p. 123.
Effect Switch
Send Level
Send Balance
Cursor
Tracl to be recorded
AUX Switch
AUX Send Switch
AUX Send Pan/Balance
Cursor
Monitor Select
Equalizer Mode
Direct Out
Effect Insert