Sharp AR-M620N, AR-M700U, AR-M550N Calling up a job program, Deleting a stored job program

REC LL

A JOB PROGRAM HAS BEEN ALREADY STORED IN THIS LOCATION.

STORING, USING AND DELETING JOB PROGRAMS

Calling up a job program

1 Press the [#/P] key.

2 Touch the number key of the desired job program.

			The	screen
JOB PROGRAMS
			automatically closes and
	PRESS PROGRAM NUMBER.
			the job program is called
			up. A number key that
			does not have a job
			program	cannot be
		RECALL

selected.

3 Set the number of copies if needed and then press the [START] key.

Copying will begin using the settings of the job program.

Deleting a stored job program

1 Press the [#/P] key.

2 Touch the [STORE/DELETE] key.

4 Touch the [DELETE] key.

The selected program is deleted and you return to the screen of step 3.

CANCEL DELETE STORE To return to the screen STORE/DELETE of step 3 without deleting the job program, touch the [CANCEL] key. In

both cases, touch the [EXIT] key on the screen displayed in the screen of step 3 to exit the job program mode.

M NUMBER.

RECALLSTORE/DELETE

3 Select a storage register number of the program to be deleted.

		If a number key for which
	EXIT
		no	job program	has
		been stored is selected,
		the screen will change to
		the screen of step 4 on
		the	previous page	(for
STORE/DELETE

storing a job program).

NOTE

If overwriting of programmed copy settings has been prohibited in the key operator programs, you will not be able to clear a job program. (See page 15 of the key operator's guide.)

5-32