Sharp AR-M700N Interrupting A Copy Run, 5-33, Touch the INTERRUPT key, document glass page

INTERRUPTING A COPY RUN

The copy of the original scanned in interrupt mode is output before the remainder of the interrupted copy job.

1 Touch the [INTERRUPT] key.

2 Place the original for the interrupt copy job in the document feeder or on the

INTERRUPT

AUTO

ORIGINA

23AUTO

A4 EXPOSUR

AUTO A4

If interrupt copying is possible during a copy run, the [INTERRUPT] key will appear. (If the key does not appear, interrupt copying is not possible.)

document glass (page 4-3).

CANCEL	0	When the [INTERRUPT]
	AUTO	key is touched in step 1,
ORIGINAL A4		the [INTERRUPT] key
	EXPOSURE
		will be replaced by the
	AUTO A4
		[CANCEL] key as shown
	PAPER SELECT

	in the illustration.
100%
OPY RATIO	To cancel an interrupt

copy job while the interrupt original is being scanned or while you are selecting copy settings, touch the [CANCEL] key.

NOTES

●If you touch the [INTERRUPT] key when auditing mode is enabled, the display will prompt you to enter your account number. Enter your account number with the numeric keys. The copies you make will be added to the count of the entered account number.

●If a copy is being printed when the [INTERRUPT] key is pressed, interrupt mode will begin after the copy is finished.

●If the copy run to be interrupted is using paper from the bypass tray, the paper size and type of the bypass tray cannot be changed for use by the interrupt job.

●If the document glass is used for an interrupt copy job, two-sided copying, sort copying, and staple sort copying cannot be selected. If any of these functions are necessary, use the document feeder.

3 Select the exposure mode, paper size, number of copies, and any other copy settings as needed, and then press the [START] key.

4 The previous copy job automatically resumes after the interrupt job finishes.

5

5-33