Sharp AR-M700N Checking the Size of a Placed Original, Manually setting the scanning size

CHECKING THE SIZE OF A PLACED ORIGINAL

If the placed original is a standard size, the size will be automatically detected (automatic original detection function) and displayed in the touch panel. Make sure that the correct size has been detected.

(A):The original size is displayed.

(B):[AUTO] appears when the automatic original detection function is

operating.

If you have loaded a non-standard size original or wish to change the scanning size, you can follow the steps below to manually set the original scanning size. (For the standard sizes, see "Original size detection function" on page 4-3.)

0

A4 AUTO ORIGINAL

AUTO

EXPOSURE

(A)(B)

NOTE

If a non-standard size original is loaded (including special sizes), the closest standard size may be displayed, or the original size may not appear at all.

If "CANCEL DETECTION AT DOCUMENT GLASS" is enabled in the key operator programs (see page 11 of the key operator’s guide), automatic original detection at the document glass will not operate. In this case, follow the steps below to manually set the original scanning size.

Manually setting the scanning size

If you load an original that is not a standard size (such as an INCH size), or if the size is not detected correctly, you must touch the [ORIGINAL] key and set the original size manually. Perform the following steps after placing the document in the automatic document feeder or on the document glass.

4

1 Touch the [ORIGINAL] key.

0

AUTO

If a non-standard size original is placed in the document feeder or on the document glass, touch the [SIZE INPUT] tab and then enter the X (width) and Y (length) dimensions of the original.

ORIGINAL

AUTO

EXPOSURE

2 Touch the desired original size key.

X		OK
	Y

X420 (64mm 432)

Y297 (64mm 297)

STANDARD SIZE SIZE INPUT

X is initially selected. Enter the X dimension (width) and then touch the Y( ) key and enter the Y dimension (length). X can be from 64 to 432 mm, and Y can be from 64 to 297 mm.

	A5	A4			OK	[AUTO]	is	no	longer
						highlighted.		[MANUAL]
A5R		A4R
					AB
						and the original size key
	B5	B4
				INCH		you	touched		are
B5R		A3				highlighted.
	STANDARD SIZE		SIZE INPUT

If you frequently use originals that are the same non-standard size, you can store the size as explained in "STORING, DELETING, AND USING ORIGINAL SIZES"on the following page. This will save you the trouble of manually entering the size each time you use that original size.

If you wish to select an INCH size, touch the [AB/INCH] key and then touch the desired original size key.

					[INCH] is	highlighted
				OK
51/2X81/2	81/2X13
					and INCH size keys are
1/2X 1/2	1/
5 8 R	82X14			AB	displayed. To return to
81/2X11	11X17				the AB palette, touch the
			INCH
81/2X11R					[AB/INCH]	key once
					again.
STANDARD SIZE		SIZE INPUT

3 Touch the [OK] key.

You will return to the initial screen.

4 The selected original size appears in the top half of the [ORIGINAL] key.

0

81/2X11

ORIGINAL

AUTO

EXPOSURE

4-5